This process will help determine whether the transmitter or the sensor has a possible fault.

Check the red “LED” is flashing briefly on the bottom of the transmitter connected to that sensor. (Every 15 Seconds for the Anemometer and 40 Seconds for the Thermo / Hygro and Rain sensors approx.) If the light stays on there maybe a fault.

If no “LED” is flashing try using the reset button inside the battery compartment  on the Transmitter. If this also fails remove the “AA” batteries and disconnect the Re-chargable battery by removing the small white plug on the end of the wire. (The Re-chargable battery can be identified by the light green cover.)

In the case where the is still no data received of “LED” flashing, swap the suspect transmitter on to another sensor. This can also be done by swapping a sensor on to one of the other Transmitters.

After re-setting both the transmitter and the indoor Console and identifying any data missing i.e. if there is “0.0” present the sensor may have a fault. If the Console shows - -  the transmitter may not be working.

If you would like further assistance with this procedure do not hesitate to call us for technical advice on 01323 472922.